Electronics (Mike Jaroch)

The difference in voltage between two points. It is the result of the loss of electrical pressure as a current flows through a resistance [1] [4].

The ratio of output voltage to input voltage in an amplifier [6].

Methods of increasing voltages; used primarily where low current is required [7].

A measure of the ability of a generator or power supply to maintain a
constant output voltage from no-load to full-load operation. Expressed as a percentage of full-load voltage; the better the regulation, the lower the percent [5].

A series-diode detector in which the diode is in series with the input voltage and the load impedance [12].

Same as END-FEED METHOD [10].

A meter used to measure voltage [3] [16].

(VSWR)—In a waveguide, the ratio of the electric field (voltage) at a maximum point to that of an adjacent minimum point [10] [18].

A slice of semiconductor material upon which monolithic ICs are produced [14].

A rotary switch in which the contacts are arranged on levels. Each level (wafer) is electrically independent but mechanically connected by the shaft of the switch [3].